HaloCalm F10 Microneedling Pen

• 1 x Halocalm F10 Microneedling Pen
• 2 x Magnetic Battery
• 1 x Multifunctional Beauty Base
• 1 x Disinfection Cup
• 5 x NK2 PRO Cartridge
• 1 x User Manual
• 1 x Type C Charger
• 1 x Type-C Cable
• 1 x Adapter

Important: Each cartridge is supplied in sealed packaging and is intended for single use only. Always inspect the packaging and cartridge before use. Do not use it if the packaging is open, damaged. Follow the cleaning steps below before use. Never reuse or share a cartridge, and dispose of it immediately after each session.

1. First, ensure that you have all the necessary equipment for cleaning and disinfection; gloves, isopropyl alcohol solution (70% or above) and a clean container to hold the solution.
2. Put on your gloves to avoid contaminating the cartridges during the sterilisation process.
3. Check on your cartridge; ensure the needles are in perfect condition (i.e. not bending) and remove any debris.
4. Pour enough alcohol solution into the container and dip the cartridge needle into a cleaning and disinfection container, then soak for a couple of minutes.
5. If you have alcohol solution in a spray model, you can spray it towards the needle head of the cartridge.
6. Once the cartridge is completely air-dried, it is ready to attach and use.

Please read our detailed instruction guide here.

1. Comprehensive instructions are available on our website under our FAQS section.
2. The cartridge comes in a sterile pack.
3. Double-cleanse (cleanse and repeat) then wipe the skin clean. Fully tie back your hair, away from your face.
4. Work in small areas and apply Hyaluronic Acid serum to each area before needling. This will help to ensure that the pen does not drag or pull on the skin. The recommended pattern to move the pen for best results is vertical, horizontal, and then diagonal in both directions. Using a light pressure and without dragging, repeat this motion over each area two times.
5. Safely dispose cartridge after every use.

DO NOT USE

• On open wounds.
• On acne or irritated skin.
• If irritation occurs.
• One cartridge more than once.

For microneedling: Microneedling should be performed once every 4-6 weeks. Results may differ for each person; the average initial result can be seen in the first 2 sessions.

For nanoneedling: Use the device once every week, can also be used between microneedling sessions. Results may differ for each person; the average initial result can be seen in the first sessions.

Please speak with your doctor before purchasing any HaloCalm products. The content on this site is not intended to substitute for the advice of a qualified physician, pharmacist, or other licensed healthcare professional. The products may have additional information and instructions on or inside the packaging that you should carefully read and follow. Contact your health-care provider immediately if you suspect that you have a medical problem. This product may not have been evaluated by the Food and Drug Administration and is not intended to diagnose, treat, cure, or prevent any disease or health condition. For any concerns or questions, please contact your GP or dermatologist.